At a glance
- Choose the leaf arrangement, opening type and pivot.
- Set the panel divisions and the construction of glazed or solid panels.
- Adjust the wall frame and the opening graphics in plan and 3D.
Leaves and opening arrangementChoose the door configuration and the widths of its leaves.
Set the overall door dimensions, then choose Single or Double and the required opening type. The pivot setting controls the opening reference.
For a double door, the leaves can share the same construction settings or use separate settings for the left and right leaves. Use the split and primary-leaf controls to define their relative widths.
Panels and framesDefine the construction within and around the leaves.
Choose the panel arrangement and adjust the rails, stiles and divisions. The glazed and solid panels have separate thickness and setback controls, allowing them to sit at different positions within the leaf.
The optional wall frame is separate from the divisions within the leaves. Set its width, depth, offset and surface to suit the wall junction.
Plan and 3D openingSet the drawing symbol separately from the model position.
The 2D opening angle and swing controls define how the door is drawn on the Floor Plan. Use these settings to communicate the opening without changing the model leaves.
The 3D opening angle positions the leaves in the model. The 3D opening lines describe their operation and can be adjusted separately from that angle.